Raspberry Pi Camera Module 3 case with tripod thread
A compact housing for the Raspberry Pi Camera Module 3, which uses a 25 x 24 mm board with 2.2 mm holes on a 21 x 12.5 mm pattern. The case is 30 x 29 x 12 mm with 1.5 mm walls, a 9 mm lens opening centred on the sensor, a slot on the bottom edge for the 15-pin ribbon cable and four M2 screw bosses. A 1/4 inch-20 threaded boss on the back accepts a standard tripod stud, and a 2 mm hole aligns with the autofocus sensor window. Print the front plate lens-down for a clean bezel and the rear body flat.
Camera cases only work when the lens hole is centred on your exact module, and Module 3 differs from V2 downloads. In SpeakCAD you describe the module, preview the case free in the browser, switch to the wide-angle or NoIR variant in the chat, and download the STL.
Model a two-part camera housing 30 x 29 x 12 mm with 1.5 mm walls for a Raspberry Pi Camera Module 3 board 25 x 24 mm with M2 bosses on a 21 x 12.5 mm pattern, a 9 mm centred lens hole, a ribbon cable slot on the bottom edge and a 1/4 inch-20 tripod boss on the back.