Every part below was generated from the prompt under it, then rendered and exported without a manual CAD step. Use the prompts as templates for your own.
Angled phone stand“A phone stand for a 75 mm wide phone, 60° viewing angle, with a slot underneath for the charging cable.”More like this →
Wall bracket for a 32 mm pipe“A wall bracket that holds a 32 mm pipe, two countersunk M4 screw holes, 4 mm walls, rounded edges.”More like this →
Snap-fit electronics enclosure“A two-part enclosure for a 65 x 30 mm PCB, 12 mm tall inside, snap-fit lid, USB-C cutout on the short side, four vent slots.”More like this →
Modular drawer organizer“A drawer organizer, 150 x 100 x 40 mm, with three compartments in a 1:1:2 ratio and 1.6 mm walls.”More like this →
Hexagonal planter with drainage“A hexagonal planter 90 mm across and 80 mm tall, 2.4 mm walls, three 6 mm drainage holes, slight taper.”More like this →
Star cookie cutter“A five-point star cookie cutter, 80 mm across, 15 mm tall blade 0.8 mm thick with a 4 mm wide flange for pressing.”More like this →
24-tooth spur gear“A 24-tooth spur gear, module 2, 8 mm thick, 6 mm D-shaft bore with a 0.5 mm flat, 4 lightening holes.”More like this →
Replacement appliance knob“A replacement knob 30 mm diameter, 18 mm tall, 6 mm D-shaft 12 mm deep, a pointer line on top, fine grip ridges.”More like this →
Describe your own
Copy a prompt above, change the numbers, and see your part render in seconds.
