1
The prompt on this page opens in SpeakCAD already filled in — after sign-in too. The model renders in your browser. Preview is free.Everyday fixes
Tesla Model Y Juniper charge-cable hook
This is not a fixed STL. SpeakCAD generates the tesla model y juniper charge-cable hook to your millimetres, you adjust it in the chat, then you download and print it.2
Change any millimetre in the chat: wall thickness, hole size, the thing it clips onto. Iterations stay in the tab until it matches what you own.Adjust
3Print
Download a watertight STL or 3MF for 2 credits, drop it in your slicer, and print it. Small fit fixes re-download free.Get it nowThe example prompt comes with you, even through sign-in. Preview is free; a download costs 2 credits.
What a tesla model y juniper charge-cable hook is
A hook that hangs a NACS charge cable on the Juniper Model Y frunk or garage wall so the cable is not on the floor. The saddle is 16 mm and two 4.5 mm holes sit on 50 mm centres. Print in PETG with 2.4 mm walls.
The Juniper console-lid organizer is a different part. In SpeakCAD you pick frunk vs wall, preview the hook in the browser at no cost, then download the STL.
Example prompt
Design a Model Y Juniper charge-cable hook, 16 mm saddle, two 4.5 mm holes on 50 mm centres, 2.4 mm PETG.
People also search
model y juniper cable hook stltesla y charge cable holder 3d printjuniper nacs hookmodel y cable hanger 3d model
Questions people ask about a tesla model y juniper charge-cable hook
A hook that hangs a NACS charge cable on the Juniper Model Y frunk or garage wall so the cable is not on the floor. The saddle is 16 mm and two 4.5 mm holes sit on 50 mm centres. Print in PETG with 2.4 mm walls.
Click Get it now on this page: the example prompt is filled in for you after you sign in. The model renders in your browser — nothing to install — and previewing is free. Adjust any millimetre in the chat, then export a watertight STL or 3MF for 2 credits when you want to print.
Start from this working example and replace any number with what you measured: Design a Model Y Juniper charge-cable hook, 16 mm saddle, two 4.5 mm holes on 50 mm centres, 2.4 mm PETG.
The Juniper console-lid organizer is a different part. In SpeakCAD you generate and preview for free, then download a file sized for the part you actually own.
No. SpeakCAD runs entirely in the browser: the chat, the 3D engine and the live viewer load in the tab. The only file you download is the finished STL or 3MF.
More everyday fixes
Tesla Model 3 seat gap filler for center consoleA wedge that fills the 25 to 35 mm gap between the front seat and the center console in a Tesla Model 3 or Model Y so keys, cards and fries stop disappearing…Uppababy Vista V3 cup-holder clampA clamp that puts a 70 mm cup on a Vista V3 handlebar, 22 mm snap and a 2 mm drain.Meshtastic T-Deck Plus dash cradleA dash cradle that holds a T-Deck Plus at 40 degrees with a 14 mm USB-C slot and a 20 mm antenna clearance.Toyota RAV4 Prime charge-cable hookA hook that hangs a RAV4 Prime J1772 cable on a garage wall so it is not on the floor.Frame bag clip for top tubeTop-tube bags held by velcro straps slide and scuff the paint, while a rigid clip holds them square.Slotted soap dish with drain channelBar soap turns to mush in a flat dish, while a slotted tray drains water and lets air reach the underside.