Logitech Brio webcam clip for thin bezel monitors
A replacement clip for the Logitech Brio 4K webcam that grips a monitor with a bezel under 6 mm, which the stock mount slides off. The Brio body is 102 x 27 x 27 mm with a 1/4 inch-20 thread on the underside, so the clip carries a 1/4 inch-20 boss on a 30 mm platform, a 12 mm hook that wraps over the top of a panel up to 12 mm thick, and a 40 mm lower arm with a 2 mm rubber pad recess that rests on the rear of the monitor. Adjustment comes from a 15 degree pivot notch series. Walls are 3 mm and it prints on its side without supports.
Monitor tops vary between 4 and 20 mm, so one downloaded clip rarely holds every screen firmly. In SpeakCAD you describe the monitor edge, preview the clip free in the browser, adapt it to a Logitech C920 or a laptop lid in the chat, and download the STL.
Design a webcam clip for a Logitech Brio with a 30 mm platform carrying a 1/4 inch-20 threaded boss, a 12 mm front hook for a monitor top up to 12 mm thick, a 40 mm rear arm with a 2 mm pad recess, notched 15 degree tilt adjustment and 3 mm walls.