Desk & office

Anker 7-in-1 USB-C hub under-desk clip holder

A holder that screws under the desk edge and grips an Anker 7-in-1 USB-C hub so its ports face forward within reach. The Anker 341 hub is 114 x 53 x 15 mm, so the holder is a C-shaped sleeve with a 115 x 16 mm opening, 0.5 mm clearance, 55 mm deep with the front face fully open for the USB-A, HDMI and card slots and a 20 mm cutout at the rear for the captive USB-C cable. Two 4 mm countersunk holes in the top flange take wood screws, and a 3M pad recess suits laminate. Walls are 2.5 mm and it prints on its side with no supports.

Hubs vary by a few millimetres between models, and a loose downloaded holder lets the hub drop when you unplug a stick. In SpeakCAD you describe the hub, preview the clip free in the browser, adapt it to an Anker 555 or a UGREEN hub in the chat, and download the STL.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design an under-desk sleeve holder for an Anker 7-in-1 USB-C hub 114 x 53 x 15 mm with a 115 x 16 mm opening and 0.5 mm clearance, 55 mm depth, an open front face, a 20 mm rear cable cutout, 2.5 mm walls and a top flange with two 4 mm countersunk screw holes.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More desk & office

Garmin Fenix and Forerunner charging cable dock standA desk dock that holds the Garmin four-pin charging plug pointing upward, so a Fenix 7 (47 mm case) or Forerunner 265 (46.1 mm case) drops onto the connector…Logitech Brio webcam clip for thin bezel monitorsA replacement clip for the Logitech Brio 4K webcam that grips a monitor with a bezel under 6 mm, which the stock mount slides off.Novation Launchpad X angled desk standAn angled stand that tilts a Novation Launchpad X, Launchpad Mini MK3 or Launchpad Pro MK3 towards you at 20 degrees so the RGB pad grid is readable standing…Pen cup with sloped compartmentsA desk pen holder divided into three angled compartments so pens, markers and scissors each lean forward and stay easy to grab.Keycap storage tray with stem postsA tray for sorting and storing loose MX-style keycaps on a grid of cross-shaped posts that hold each cap upright and prevent scuffing.Apple Watch Series 10 charger dock for nightstandA compact dock that holds the Apple Watch magnetic charging puck (27.9 mm diameter, about 6 mm high) at 70 degrees so a Series 10 in either 42 or 46 mm charg…

Make your anker 7-in-1 usb-c hub under-desk clip holder now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.