Hex dumbbell wall mount holder bracket
A pair of wall brackets that cradle a rubber hex dumbbell by its handle so a small home gym stays off the floor. Each bracket has a 35 mm wide, 30 mm deep U-shaped cradle for a 32 mm handle, a 60 mm tall back plate with two countersunk 5 mm screw holes on 32 mm centres, and 6 mm walls with a 45 degree gusset under the cradle. Print it standing on the back plate so the load runs along the layers rather than across them, in PETG at 40 percent infill, and screw it into a stud or plywood backing rated for the weight.
Dumbbell handles range from 25 to 35 mm and head widths differ by brand, so an off-the-shelf model either pinches or lets the bell roll. Tell SpeakCAD your handle diameter, head spacing and weight, preview the bracket free in the browser, adjust the gusset in the chat, then download the STL.
Design a wall bracket for a hex dumbbell with a U-shaped cradle 35 mm wide and 30 mm deep for a 32 mm handle, a 60 x 50 mm back plate with two countersunk 5 mm holes 32 mm apart, 6 mm walls and a 45 degree gusset.