Enclosures & cases

Bosch Kiox e-bike display holder cover cap

When you take the Bosch Kiox display off a Cube, Riese und Muller or Trek e-bike, the magnetic holder and its charging contacts are left exposed to rain and grit. This cap snaps over the empty holder with 1.8 mm walls, a 0.3 mm clearance around the body and two 1 mm snap lips on the long sides, and a small pull tab so it comes off with a fingernail. The pocket is sized to the measured holder, roughly 70 x 40 x 12 mm, and it prints open-face down in PETG or TPU for a softer grip.

A measured cover fits the holder tightly enough to stay on over cobbles, unlike a generic download that falls off at the first pothole. In SpeakCAD you type the length, width and height of your holder, preview the cap free in the browser, adjust the snap lips in the chat, then download the STL.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a snap-on cover cap for a 70 x 40 x 12 mm display holder with 1.8 mm walls, 0.3 mm clearance, two 1 mm snap lips along the long sides, a 10 x 6 mm pull tab on one end and 1 mm rounded outer edges.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More enclosures & cases

Case for an LM2596 buck converter moduleA tidy shell for the common 43 x 21 mm LM2596 step-down module, covering the exposed inductor and trimmer while leaving the input and output terminals reacha…Apple Watch Ultra charger puck travel case with cable wrapA pocket-size case for the Apple Watch magnetic fast charger used by the Ultra and Series 10, holding the puck (27.9 mm diameter, about 6 mm high) in a 28.4…Shimano STEPS SC-E5000 display protective coverThe Shimano STEPS SC-E5000 display sits proud of the handlebar and is easily scratched when an e-bike is parked in a crowded rack or leaned against a wall.Wemos D1 Mini enclosure with DHT22 sensor slotA wall-mountable box for a Wemos D1 Mini (34.2 x 25.6 mm) with a dedicated slot for a DHT22 temperature and humidity sensor.Raspberry Pi Camera Module 3 case with tripod threadA compact housing for the Raspberry Pi Camera Module 3, which uses a 25 x 24 mm board with 2.2 mm holes on a 21 x 12.5 mm pattern.Kia EV6 key fob cover with lanyard loopA protective sleeve for the Kia EV6, Niro EV and Hyundai Ioniq 5 smart key, which shares the same 5-button fob body.

Make your bosch kiox e-bike display holder cover cap now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.