AirPods Pro 2 case charging stand for MagSafe puck
A small stand that holds an Apple MagSafe puck at 70 degrees and cradles the AirPods Pro 2 case (60.6 x 45.2 x 21.7 mm) against it, aligning the case coil with the puck so it charges every time you set it down. The puck pocket is 56.4 mm with a 1.2 mm lip, the case slot is 46 x 22.5 mm with an open front so the lid still flips up, and the cable runs through a channel in the 70 x 60 mm base. Walls are 2.5 mm and it prints upright.
The AirPods coil is off-centre and a downloaded stand that misses it by a few millimetres will silently not charge. In SpeakCAD you describe your puck and earbuds case, preview the stand free in the browser, refine the case slot in the chat, then download the STL.
Model an AirPods Pro 2 charging stand with a 56.4 mm diameter, 5.5 mm deep MagSafe puck pocket tilted 70 degrees, a 46 x 22.5 mm case slot 15 mm deep centred on the puck with an open front, a 70 x 60 x 10 mm base with a cable channel and 2.5 mm walls.