Starlink Gen 3 router wall mount bracket
A bracket that stands the Starlink Gen 3 router upright on a wall or under a shelf so it does not take up a desk. The router is a flat slab roughly 250 mm tall, 120 mm wide and 30 mm thick with the power and two Ethernet ports on the bottom edge, so the bracket is a U-shaped cradle 125 mm wide with a 32 mm internal gap, 40 mm tall side walls, a 3 mm base and a 40 x 20 mm cutout under the ports so cables hang straight down. Two 4 mm countersunk holes at 80 mm spacing go into the wall. Walls are 3 mm and it prints flat on its back.
Router measurements shift between hardware revisions, so a downloaded bracket for the Gen 2 will not hold this one. In SpeakCAD you describe your router, preview the bracket free in the browser, add a top lip or a mesh node version in the chat, and download the STL.
Design a U-shaped wall cradle for a Starlink Gen 3 router 120 mm wide and 30 mm thick with a 32 mm internal gap, 125 mm outer width, 40 mm tall side walls, a 3 mm base with a 40 x 20 mm cable cutout, 3 mm walls and two 4 mm countersunk wall holes at 80 mm spacing.