Amazon Eero Pro 6 wall mount bracket
A wall bracket for the Amazon Eero Pro 6 mesh node, a 137 x 137 x 48 mm unit whose power and Ethernet ports sit on the back. The bracket is a 140 x 50 mm shelf with a 4 mm raised rim on three sides, two 20 mm rear cutouts aligned with the port area so cables route down the wall, and a 60 mm tall back plate with two 4 mm countersunk holes at 100 mm spacing. A 2 mm channel around the edge of the shelf holds a rubber band or strap if the router is mounted upside down in a ceiling void. Walls are 3 mm and the part prints flat on its back.
Mesh nodes are hard to place well with sticky pads and a generic download does not know where the Eero's ports are. In SpeakCAD you describe the node, preview the bracket free in the browser, adapt it to the Eero 6+ or Pro 6E in the chat, and download the STL.
Design a wall shelf bracket for an Amazon Eero Pro 6 router 137 x 137 x 48 mm with a 140 x 50 mm platform, 4 mm rim on three sides, two 20 mm rear cable cutouts, a 60 mm back plate with 4 mm countersunk holes at 100 mm spacing, 3 mm walls and a 2 mm strap groove.