Brackets & mounts

Ring Video Doorbell 30 degree wedge mount

An angled spacer that turns a Ring Video Doorbell 2nd gen towards the path when the door sits in a recess. The doorbell is 126.7 x 62.2 x 28.5 mm and screws to a plate with two vertical holes 90 mm apart, so the wedge reproduces that plate pattern on its front face, rotated 30 degrees around the vertical axis, and carries two 5 mm slotted holes on the back for wall plugs. A 14 mm channel runs through the wedge for the doorbell wire, and 3 mm walls with 20 percent infill keep it stiff. Print it face up with the thin edge supported by a brim.

Ring sells 15 and 30 degree wedges, but not for every door frame, and downloads rarely match the 2nd gen hole spacing. In SpeakCAD you describe the doorbell, preview the wedge free in the browser, set your own angle or adapt to a Doorbell 4 in the chat, and download the STL.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a 30 degree horizontal wedge mount for a Ring Video Doorbell 2nd gen 126.7 x 62.2 mm with two M4 screw bosses 90 mm apart on the angled front face, two 5 mm slotted wall holes on the back, a 14 mm through channel for the bell wire, 3 mm walls and 2 mm edge fillets.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More brackets & mounts

Ryobi ONE+ battery wall mount strip for 18V packsA strip of sockets for Ryobi ONE+ 18V batteries, from the slim 1.5 Ah to the 6 Ah High Performance packs, which all share the same stem.Owlet Dream Sock base station wall mountA cradle that holds the Owlet Dream Sock or Smart Sock 3 base station on the nursery wall at eye level so the glowing ring is visible from the door and the c…Curtain rod bracket for a 25 mm poleA replacement or extra bracket for a 25 mm curtain pole when the set came with too few or one broke.Adjustable support bracket for a sagging graphics cardA telescoping pillar that stands on the PC case floor or power supply shroud and props up the far end of a heavy graphics card so it stops drooping in the PC…Garmin Edge 840 out-front mount for 31.8 mm barsAn out-front mount that clamps a 31.8 mm road handlebar and holds a Garmin Edge 840 (or the identically sized Edge 540) level with the stem, roughly 75 mm ah…Sonos Roam wall holder with USB-C charging cutoutA cradle that holds a Sonos Roam upright on a bathroom or kitchen wall while a USB-C cable stays plugged into the back.

Make your ring video doorbell 30 degree wedge mount now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.