Philips Hue Play light bar monitor clip mount
A clip that hangs a Philips Hue Play light bar on the back of a monitor without the stock adhesive feet. The Play bar is about 253 x 44 x 36 mm, so the mount is a pair of cradles with a 45 x 37 mm saddle, 0.5 mm clearance and a 2 mm lip that stop the bar sliding, each attached to a hook that grips a 20 to 30 mm thick monitor back via a 10 mm rubber-padded pad. The cradles angle the bar 15 degrees towards the wall for an even wash. Walls are 3 mm and the parts print flat on the hook face without supports.
Monitor thicknesses vary so a shared download often ends up loose or scratching the panel. In SpeakCAD you describe your monitor edge and bar, preview the clips free in the browser, swap the hook for a VESA-screw version in the chat, and download the STL.
Design a pair of clip mounts for a Philips Hue Play light bar 253 x 44 x 36 mm with a 45 x 37 mm saddle and 0.5 mm clearance, a 2 mm retaining lip, a 15 degree wall-facing tilt, a hook for a 25 mm thick monitor back with a 10 mm pad and 3 mm walls throughout.