Enclosures & cases

SONOFF ZBDongle-E protective case with USB extension slot

A wraparound sleeve for the SONOFF ZBDongle-E Zigbee coordinator, which measures about 65 x 23 x 12 mm including its USB-A plug and carries an SMA antenna connector on the opposite end. The sleeve is 71 x 29 x 18 mm with 1.6 mm walls, open at both ends so the USB plug and the 5 dBi antenna pass through, and it grips the dongle on internal 0.5 mm ribs. A slot on one face exposes the status LED and a 4 mm hole plus a screw slot let you hang the dongle on a wall at the end of a USB extension cable, away from USB 3.0 interference. Prints flat with no supports.

A sleeve sized to your exact dongle and mounting spot beats a general download. In SpeakCAD you describe it, preview the case free in the browser, ask the chat to adapt it for the ZBDongle-P or a ConBee, and download the STL when it fits.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Create an open-ended protective sleeve 71 x 29 x 18 mm with 1.6 mm walls for a SONOFF ZBDongle-E Zigbee dongle 65 x 23 x 12 mm, internal 0.5 mm grip ribs, a 6 x 3 mm LED slot, a 4 mm wall screw hole and a keyhole slot for hanging on a USB extension cable.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More enclosures & cases

AirPods Pro 2 case belt clip with carabiner holeA snap-on sleeve for the AirPods Pro 2 charging case (60.6 x 45.2 x 21.7 mm) with a spring belt clip on the back and a 6 mm carabiner hole on top, so the ear…Raspberry Pi Zero 2 W slim snap-fit caseA minimal shell for the Raspberry Pi Zero 2 W, which measures 65 x 30 mm with four M2.5 holes on a 58 x 23 mm pattern.Heltec LoRa V3 Meshtastic case with SMA antenna holeA rugged node case for the Heltec WiFi LoRa 32 V3, the board most Meshtastic beginners start with.MeanWell LRS-350 terminal cover with strain reliefA snap-on guard for the exposed screw terminals on a MeanWell LRS-350 series power supply, whose chassis is 215 x 115 x 30 mm with the terminal block at one…Screw-lid enclosure for an 80 x 50 mm PCBA general purpose electronics box for a custom 80 x 50 mm circuit board, with four corner posts, a screw-down lid and blank walls you can specify openings in…Case for an LM2596 buck converter moduleA tidy shell for the common 43 x 21 mm LM2596 step-down module, covering the exposed inductor and trimmer while leaving the input and output terminals reacha…

Make your sonoff zbdongle-e protective case with usb extension slot now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.