Wall mount clips for a power strip
A pair of C-shaped clips that screw to a wall or cabinet side and let a power strip slide in and stay put, so it stops dangling from its cord. Each clip wraps the strip's cross-section with about 0.4 mm of clearance, has a 3 mm wall, a 20 mm wide back with two 4 mm screw holes and a slight inward lip on the open side so the strip cannot fall out on its own. Print them lying on the back plate for strength.
The cross-section of a power strip is unique to its brand, which is why downloaded clips are usually too loose or too tight. Measure width and thickness, tell SpeakCAD, and the clips are generated to that profile. Try it free in the browser and refine the grip with a follow-up message.
Make two C-shaped wall clips for a power strip 62 mm wide and 38 mm thick. Inner opening 62.4x38.4 mm, 3 mm walls, 20 mm deep, back plate with two 4 mm countersunk holes 12 mm apart, and a 1.5 mm inward retaining lip on the open edge.