Godox V1 flash foot stand with 1/4 inch thread
A replacement mini stand for a Godox V1, V860III or TT685 speedlight that has lost the plastic foot it shipped with. The standard ISO flash foot is 18.7 mm wide and about 2 mm thick, so the slot is 19 mm wide with a 2.3 mm gap, a 1 mm entry ramp and a rear stop, and the 70 x 55 mm base has three 8 mm cable notches so the stand sits flat on a table during off-camera work. A 1/4-20 threaded bore runs through the base so it screws onto a light stand, Manfrotto Nano stand or tripod, and the top surface is textured so the flash will not spin. Print it standing with 2.5 mm walls.
The original feet vanish at every shoot, and generic ones are loose on the round-head Godox. Describe the flash foot you measured in SpeakCAD, preview the stand in the browser without paying, add a second slot for a trigger in the chat, then download the STL.
Design a speedlight foot stand for a Godox V1 with a 19 mm wide, 2.3 mm tall shoe slot 22 mm deep, a 1 mm entry ramp and rear stop, a 70 x 55 x 12 mm base with three 8 mm cable notches, a 1/4-20 threaded bore 10 mm deep through the base and 2.5 mm walls.