Tools & jigs

Glue bottle stand with roller applicator holder

Wood glue bottles stored upright form a crust in the nozzle, while a bottle stored tip-down dispenses instantly. This stand holds a 500 ml bottle inverted in a 72 mm cup with a small catch well, and adds slots for a glue roller and a silicone brush so the whole glue-up kit lives in one spot. The base is 150 x 90 x 25 mm with 3 mm walls and a 90 mm tall cradle. Print upright; PETG cleans up better than PLA when cured glue is peeled off.

Give SpeakCAD your bottle diameter and the tools you want stored and it makes a stand for your bench, not a generic one. Adding a second cup or a wall-mount tab takes one more message. Preview for free before you download.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Model a glue bottle stand 150 x 90 x 25 mm with an inverted bottle cup 72 mm inner diameter and 90 mm tall, a 6 mm drip well, a 40 x 15 mm slot for a glue roller, a 25 x 8 mm brush slot, and 3 mm walls.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More tools & jigs

Pocket-hole drilling jig blockThis jig guides a stepped 9.5 mm pocket-hole bit at the standard 15 degree angle into the edge of 18 mm sheet goods, for pocket-screw cabinet joints without…Router circle-cutting jigA trammel jig lets a trim router cut clean circles and arcs by pivoting around a pin.Shelf pin drilling template, 32 mm systemAdjustable shelving needs columns of 5 mm holes at precise 32 mm spacing, and this template makes that reliable with a hand drill.Labeled socket organizer railLoose sockets in a drawer cost minutes on every job; a rail with sized posts keeps a 1/2 inch drive set in order and shows the size on each post.Shimano SPD cleat alignment jig for cycling shoesA jig that holds a Shimano SM-SH51 or SH56 SPD cleat at a repeatable fore-aft position and angle while you tighten the two M5 bolts (14 mm apart), so a new p…Dremel 4000 plunge router base with depth stopA small router base that threads onto the nose of a Dremel 4000, 3000 or 8220 so the tool can cut inlays, dados and hinge recesses with a 3.2 mm shank bit.

Make your glue bottle stand with roller applicator holder now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.