Garmin Fenix and Forerunner charging cable dock stand
A desk dock that holds the Garmin four-pin charging plug pointing upward, so a Fenix 7 (47 mm case) or Forerunner 265 (46.1 mm case) drops onto the connector and stands upright while charging. The plug body sits in a keyed slot around 13 x 8 mm, adjustable in the prompt to your cable, and the cable exits through a 4 mm channel in the 60 x 50 mm base. A shallow 48 mm saddle above the plug supports the watch case while the strap hangs either side; walls are 2.5 mm and it prints upright.
Garmin plugs are all the same connector but the overmould differs between cables, so a downloaded dock may not clip yours. In SpeakCAD you give the plug measurements and your watch case size, preview the dock free in the browser, refine the saddle in the chat, then download the STL.
Create a Garmin watch charging dock with a 13 x 8 x 12 mm keyed slot holding the four-pin plug pointing up, a 4 mm cable channel through a 60 x 50 x 12 mm base, a 48 mm wide curved saddle 10 mm above the plug and 2.5 mm walls.