Enclosures & cases

Apple Watch Ultra charger puck travel case with cable wrap

A pocket-size case for the Apple Watch magnetic fast charger used by the Ultra and Series 10, holding the puck (27.9 mm diameter, about 6 mm high) in a 28.4 mm recess while the 1 m cable winds around a spool inside the lid. The USB-C plug tucks into a 12.5 x 7 mm slot so nothing rattles, the two halves close with a snap lip and 0.15 mm clearance, and the closed case is 65 x 65 x 22 mm with 1.6 mm walls. Both halves print open side up.

Downloaded cases are drawn for the older Lightning puck and leave the fast charger loose. In SpeakCAD you say which puck and cable length you have, preview the case free in the browser, add a hinge or an AirPods pocket in the chat, then download the STL.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a two-part travel case 65 x 65 x 22 mm with a 28.4 mm diameter, 6.5 mm deep pocket for an Apple Watch charger puck, an internal spool 20 mm wide for a 1 m cable, a 12.5 x 7 mm USB-C plug slot, a snap-fit lid with 0.15 mm clearance and 1.6 mm walls.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More enclosures & cases

SONOFF ZBDongle-E protective case with USB extension slotA wraparound sleeve for the SONOFF ZBDongle-E Zigbee coordinator, which measures about 65 x 23 x 12 mm including its USB-A plug and carries an SMA antenna co…Vented case for a Raspberry Pi 4A two-part shell for the Raspberry Pi 4 that protects the board while keeping it cool, with cut-outs for USB, Ethernet, HDMI, audio, USB-C power and the micr…Vented housing for a temperature and humidity sensorA louvred shell for a DHT22, BME280 or similar sensor that shields it from direct light and drips while letting air circulate, so readings reflect the room r…Slim case for a Raspberry Pi PicoA low-profile shell for the Raspberry Pi Pico that guards the board and exposes only the micro USB connector and the BOOTSEL button.AirPods Pro 2 case belt clip with carabiner holeA snap-on sleeve for the AirPods Pro 2 charging case (60.6 x 45.2 x 21.7 mm) with a spring belt clip on the back and a 6 mm carabiner hole on top, so the ear…Raspberry Pi Zero 2 W slim snap-fit caseA minimal shell for the Raspberry Pi Zero 2 W, which measures 65 x 30 mm with four M2.5 holes on a 58 x 23 mm pattern.

Make your apple watch ultra charger puck travel case with cable wrap now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.