Suspended puppy wobble platform

Suspended puppy wobble platform is a 3D printable model by Nix on the SpeakCAD marketplace, 509 × 509 × 320 mm: STL and 3MF, free, editable with AI in the browser before you print it.

About this model

The suspended puppy wobble platform is to give young puppies a confidence building exercise. The centre platform is 40cm square. A rubber mat is required to provide a non slip surface on the platform. One of the parts is for the rubber mat so you could 3d print a low height cutting template.

The assembled swing frame is 700 mm tip to tip and 320 mm tall, with the 400 × 400 mm platform hanging above the base centre on four chains.

Parts (across x build plates: - 2 base centres, one each of A and B - 4 base ends - 4 post lowers - 4 post uppers - 4 platform quadrants - 4 rubber pads (cutting template) - 24 couplers: 12 for the frame and 12 for the platform seams.

Purchase: Rubber mat or EVA foam Chain 4 x carabineers

I recommend gluing the connectors in place for more strength.

Plate1: one base end and one post lower, all lying flat with no supports. Print this plate 4 times to get all base ends and post lowers.

Plate 2: 2 post uppers Both lie flat with the clip hole and hexes vertical, so they print without supports. Print this plate twice to get all four post uppers.

Plate 3: one base centre. Print it twice.*Base centre A and B are actually the same part: B is A turned over, so the cross slot opens on the other side. Two prints give you both, and they still slot together as an X. Iit lies flat with the hexes and sockets vertical, so it prints without supports.

Plate 4: One platform quadrant. Print it 4 times to get the whole 400 × 400 mm platform. It lies with its bottom face on the bed and the eyelet pointing up. The eyelet hole is a teardrop, and the seam sockets are covered by bridges of about 25 mm, so it prints without supports.

Plate 5: Optional print - cutting template for rubber pad. Print it 4 times.

Plate 6: 12 couplers. Print it twice to get all 24 couplers: 12 for the frame and 12 for the platform seams. print at 100% infill, since they carry every joint.