Wall bracket for a 32 mm pipe
A two-screw saddle bracket that holds a 32 mm round pipe or tube flush against a wall, useful for waste pipes, indoor garden lines or a curtain-weight dowel. The saddle should have a 33 mm inner diameter so the pipe slides in without forcing, a 4 mm wall and two 4.5 mm countersunk screw holes 60 mm apart on the base plate. A small fillet where the saddle meets the base stops cracking along the layer lines when the pipe is pushed in.
With SpeakCAD you type the pipe diameter you actually measured instead of settling for a nearby size someone else uploaded. If the preview sits too tight or the screw spacing misses your studs, say so in the chat and a corrected model appears in seconds. Previewing costs nothing and runs in your browser.
Design a wall saddle bracket for a 32 mm outer diameter pipe. Inner radius 16.5 mm, saddle wall 4 mm, 25 mm wide. Base plate 90x25x4 mm with two 4.5 mm countersunk holes 60 mm apart. Add 2 mm fillets at the saddle-to-base junction.