Brackets & mounts

Wall mount plate for a Raspberry Pi 4

A flat carrier plate that screws to a wall or cabinet and holds a bare Raspberry Pi 4 on standoffs, keeping all ports reachable and the board open for cooling. The Pi's mounting holes sit at 58 x 49 mm; the plate needs four 6 mm tall standoffs with 2.5 mm holes for M2.5 screws, a 3 mm base and two 4 mm wall slots that clear the connectors. A 5 mm gap around the board edge leaves room for a HAT.

Describe which board you have, how tall the standoffs should be and where the wall screws should land, and SpeakCAD produces a plate for exactly that. Want extra standoffs for a fan HAT or a cable tie loop? Add it in the chat. Previewing is free in your browser.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a wall mount plate for a Raspberry Pi 4. Plate 95x70x3 mm with rounded corners. Four standoffs 6 mm tall, 6 mm diameter, 2.5 mm holes at 58x49 mm spacing. Two 4x8 mm wall slots beside the board and a 5 mm cable tie loop on one edge.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More brackets & mounts

Shimano Di2 junction box holder for 31.8 mm handlebarThe Shimano SM-EW90 Di2 junction A normally hangs under the stem on a rubber band, where it rattles and gets pulled by the bar bag straps.Milwaukee M12 battery wall mount holder for 4 packsA wall strip with four sockets that grip the stem of Milwaukee M12 batteries, from the compact CP1.5 to the XC6.0, so charged packs hang ready beside the cha…Gillette Fusion razor wall holder with adhesive padA wall holder that grips a Gillette Fusion, ProGlide or Harry's Truman handle by its neck so the cartridge hangs in the air and dries instead of rusting on t…L-shaped shelf bracket, 150 mm reachA simple right-angle bracket for a light shelf up to about 150 mm deep, holding books, small speakers or plants in a hallway.Pole mount bracket for a 40 mm mastA two-piece clamp that grips a 40 mm round mast and offers a flat face with screw holes for a small antenna or outdoor Wi-Fi unit.iPad mini car headrest mount for back seatA rear-seat holder for the iPad mini (195.4 x 134.8 x 6.3 mm) that clamps to the two headrest posts so children can watch films in landscape.

Make your wall mount plate for a raspberry pi 4 now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.