Owlet Dream Sock base station wall mount
A cradle that holds the Owlet Dream Sock or Smart Sock 3 base station on the nursery wall at eye level so the glowing ring is visible from the door and the cable runs tidily down to the outlet. The base station is a puck about 85 mm in diameter and 25 mm thick, so the mount has an 86 mm ring with a 0.5 mm clearance, a 12 mm front lip that stops the station tipping forward, and a 15 mm slot at the rear for the charging cable. A 60 by 90 mm back plate takes two screws or an adhesive strip. Walls are 3 mm; print flat.
Base stations differ slightly across Owlet generations and some households prefer a shelf near the crib, so a mount generated for your unit fits snugly. In SpeakCAD you give the puck diameter and mounting method, preview the cradle in the browser at no cost, tilt it 15 degrees in the chat and download the STL.
Model a wall cradle with a 60 x 90 mm back plate 3 mm thick with two 4.5 mm screw holes, an 86 mm inner diameter ring 28 mm deep with a 12 mm front lip for an Owlet Dream Sock base station 85 mm in diameter, a 15 mm wide rear cable slot and 3 mm walls throughout.