Enclosures & cases

M5Stack Atom Lite housing with Grove port cutout

An outer housing that lets an M5Stack Atom Lite (24 x 24 x 10 mm) be screwed to a wall or DIN box while its Grove connector stays accessible. The Atom slides into a 25 x 25 mm pocket with 1.5 mm walls, a 10 x 7 mm cutout on the base face for the Grove cable, a 12 x 7 mm cutout for the USB-C port and a 6 mm opening over the RGB LED so it stays visible as a status light. Two 3.5 mm countersunk screw holes sit on flanges either side, and the back has a 2 mm channel so the Grove cable can be routed flat against the wall. Prints flat with no supports.

A housing built around your Atom variant and cable direction fits better than a shared download. In SpeakCAD you describe it, preview the housing free in the browser, change it for an Atom Matrix or AtomS3 with a screen in the chat, and download the STL.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Model a wall housing with 1.5 mm walls holding an M5Stack Atom Lite 24 x 24 x 10 mm in a 25 x 25 mm pocket, a 10 x 7 mm Grove port cutout, a 12 x 7 mm USB-C cutout, a 6 mm LED window, two 3.5 mm countersunk screw flanges and a 2 mm rear cable channel.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More enclosures & cases

Vented housing for a temperature and humidity sensorA louvred shell for a DHT22, BME280 or similar sensor that shields it from direct light and drips while letting air circulate, so readings reflect the room r…Slim case for a Raspberry Pi PicoA low-profile shell for the Raspberry Pi Pico that guards the board and exposes only the micro USB connector and the BOOTSEL button.AirTag dog collar holder for 20 mm collarsA screw-closed AirTag holder that slides onto a 20 mm dog collar and sits flat against the neck, so the tag does not dangle, jingle or snag in bushes.Raspberry Pi 5 case with active cooler cutoutA two-part snap-fit case sized for the Raspberry Pi 5, whose board measures 85 x 56 mm with M2.5 mounting holes on a 58 x 49 mm pattern.Adafruit Feather case for a FeatherWing stackAn enclosure built around the Adafruit Feather form factor: 50.8 x 22.8 mm boards with 2.5 mm mounting holes on a 45.72 x 17.78 mm pattern.Raspberry Pi Pico W enclosure with header slotsA small box for the Raspberry Pi Pico W, a 51 x 21 mm board with two M2 holes on a 47 x 11.4 mm pattern and a castellated 40-pin edge.

Make your m5stack atom lite housing with grove port cutout now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.