Kong dog toy drying rack and wall holder
A wall rack that holds stuffed Kong Classic toys upside down so they drain and dry after washing, and doubles as the place where the toys live between uses. The large Kong Classic has a small end around 35 mm across and a wide end around 75 mm, so each cradle is a 40 mm ring with a 60 mm tapered cup below that catches drips and a 10 mm gap for airflow. Three cradles sit on a 260 by 80 mm back plate with two 5 mm screw holes, and a lipped tray along the bottom catches any water. Walls are 3 mm; print flat on the back plate in PETG for easy scrubbing.
Kong sizes run from XS to XXL and a household may have several, so a rack generated to your toys holds each one properly. In SpeakCAD you list the Kong sizes and how many, preview the rack in the browser at no cost, add hooks for rope toys in the chat and download the STL.
Design a wall rack with a 260 x 80 mm back plate 3 mm thick with two 5 mm screw holes, three cradles each with a 40 mm ring and a 60 mm tapered cup 40 mm tall with a 10 mm airflow gap for inverted large Kong Classic toys, and a 15 mm lipped drip tray.