Keurig K-Cup drawer insert with 24 pod slots
A flat insert that drops into an existing kitchen drawer and holds 24 K-Cup pods upright in a four by six grid. Each pocket is 51 mm in diameter to clear the 50 mm K-Cup rim and 20 mm deep, enough to stop pods sliding while leaving the printed label readable from above. The base is 2 mm thick with 1.2 mm dividers, and drainage gaps in the corners let crumbs fall through when you lift it out to clean. It prints flat with no supports in about three hours on a 0.6 mm nozzle.
Kitchen drawers are rarely the same size twice, so an insert grabbed from a model site tends to slide or leave dead space. In SpeakCAD you type the interior width and depth of your drawer and how many pods you want, preview the insert in the browser at no cost, change the grid in the chat and download the STL or 3MF.
Design a drawer insert 320 mm wide, 220 mm deep and 22 mm tall with a 2 mm base and 1.2 mm dividers forming a 4 x 6 grid of round pockets 51 mm in diameter and 20 mm deep for Keurig K-Cup pods, with 3 mm drainage gaps at each pocket corner.