Desk & office

Elgato Wave 3 microphone desk riser with cable slot

A riser that lifts the Elgato Wave:3 closer to mouth height without a boom arm. The Wave:3 is 153 x 66 x 40 mm and sits on a 66 mm round stock base with a 1/4 inch-20 thread underneath the yoke, so the riser is a 100 mm diameter, 120 mm tall column with a 1/4 inch-20 boss on top, a 12 mm cable channel down the back for the USB-C lead, and a 6 mm deep pocket under the base for a rubber sheet that isolates desk vibration. Walls are 3 mm with 10 percent infill so it can be filled with rice or sand to add mass. Print it upright with no supports.

Microphone height depends on your chair and desk, which a downloaded riser cannot account for. In SpeakCAD you describe the mic and the height you need, preview the riser free in the browser, adapt it for a Wave:1 or a Razer Seiren in the chat, and download the STL.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a cylindrical microphone riser 100 mm diameter and 120 mm tall for an Elgato Wave:3 with a 1/4 inch-20 threaded boss on top, a 12 mm cable channel down the back, 3 mm walls, a hollow weightable interior and a 6 mm deep rubber pad recess in the base.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More desk & office

Adhesive desk cable clip setA set of low-profile clips that stick to the edge of a desk and hold charging cables.Mouse bungee with weighted baseA desk accessory that lifts a wired mouse cable off the mat so it never snags or drags.iPad Air 11 inch drawing stand with Apple Pencil trayA low-angle drawing stand for the iPad Air 11 (247.6 x 178.5 x 6.1 mm) that props the tablet at 20 degrees like a drafting board, with a groove along the fro…Elgato Stream Deck MK.2 under-monitor mountA bracket that hangs an Elgato Stream Deck MK.2 below the bottom edge of a monitor so it stays in reach without a footprint on the desk.Amazon Echo Show 5 adjustable tilt desk standA stand that raises the Amazon Echo Show 5 and tilts it so the screen is visible when standing at a kitchen counter or desk.Under-desk headphone holder with screw mountA curved hanger that screws to the underside of a desk so headphones hang within reach.

Make your elgato wave 3 microphone desk riser with cable slot now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.