EDC pocket organizer clip for pen and torch
An EDC organizer clip holds a pen and a small torch together on a pocket edge so they do not sink to the bottom. The clip has a 3 mm thick spring arm 40 mm long with a 1 mm inward lip, two snap channels sized 10 mm for a pen and 20 mm for a torch with 3 mm openings, and a 50 x 30 mm body with 1.5 mm edge fillets. PETG or nylon give the spring the fatigue life a pocket clip needs, and printing the channels vertically keeps them round.
Every pen and torch has a different diameter, so a clip generated by SpeakCAD to your gear's measurements grips without slipping or cracking. Swap the torch channel for a knife or add a third slot in the chat and preview free in the browser.
Create an EDC pocket clip with a 50 x 30 x 5 mm body, a 3 mm spring arm 40 mm long with a 1 mm inward lip, a 10.2 mm pen snap channel with a 7 mm opening, and a 20.2 mm torch channel with a 14 mm opening.