Wyze Cam v3 corner wall mount with rain hood
A corner bracket for the Wyze Cam v3, a 51 x 53 x 58 mm camera with a 1/4 inch-20 thread in its base. The bracket has two 45 mm wings that meet at 90 degrees, each with a 4 mm countersunk hole, and a 40 mm arm ending in a 1/4 inch-20 bolt boss so the camera's tilt base screws on. A 70 x 60 mm hood extends 45 mm forward above the camera to keep rain and glare off the lens, with a 5 mm slot for the USB power cable. Walls are 3 mm with 20 percent infill and the part prints hood-down with the wings supported by a brim.
Corner angles and eave depths differ from house to house, so a downloaded hood is often too short. In SpeakCAD you describe the spot, preview the bracket free in the browser, make it deeper or fit a Wyze Cam OG in the chat, and download the STL in weather-resistant PETG or ASA.
Design a 90 degree corner bracket for a Wyze Cam v3 with two 45 mm wings each having a 4 mm countersunk hole, a 40 mm arm with a 1/4 inch-20 bolt boss, a 70 x 60 mm rain hood extending 45 mm forward with a 5 mm cable slot, 3 mm walls and 2 mm edge fillets.