Replacement parts

Vacuum cleaner hose end cuff

The cuff where a vacuum hose meets the wand or floor head cracks from years of twisting, and once it splits the suction leaks away. A replacement cuff is a two-diameter sleeve: one end grips the hose ribs, typically 38 mm, and the other slides into a 35 mm tool port with a slight taper for a snug friction fit. Length is around 60 mm with 2.5 mm walls and a finger ridge for pulling. Print it upright in PETG, or TPU for extra grip.

Measuring two diameters is all SpeakCAD needs to produce a cuff for your brand and model, no part number required. If the fit is too tight after a test print, ask for 0.2 mm more clearance and try again. The preview is free in the browser.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a vacuum hose cuff 60 mm long: hose side 25 mm long with 38.5 mm inner diameter and internal ribs for a corrugated hose, tool side 30 mm long tapering from 34.8 to 34.5 mm outer diameter, 2.5 mm walls, and a 4 mm finger ridge.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More replacement parts

Washing machine door handle replacementFront-loader door handles snap at the pivot lugs after years of use, and manufacturers frequently charge a premium for a small plastic lever.Cordless drill battery latch buttonThe spring-loaded latch button that locks a battery pack into a cordless drill wears out or snaps its tab, so the pack slides off mid-job.Blender lid center capThe removable center cap of a blender lid gets lost or cracked, and without it every smoothie splashes the counter.Headset spacer set for 1 1/8 inch 28.6 mm steererStack-height spacers for a 1 1/8 inch fork steerer, 28.6 mm nominal, in 2.5, 5, 10 and 15 mm thicknesses so you can dial in bar height on a Canyon, Trek or S…Yeti Rambler MagSlider lid slider replacementThe magnetic slider on a Yeti Rambler 20 oz or 30 oz tumbler lid is the part that goes through the dishwasher, gets lost, and costs almost as much as a new lid.Bambu Lab X1C purge wiper replacement bladeA replacement for the small nozzle wiper blade at the rear of the Bambu Lab X1 Carbon and P1S, which wears a groove after a few hundred hours and stops clean…

Make your vacuum cleaner hose end cuff now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.