Hobby & gaming

Nintendo Switch 2 Pro Controller display stand

A low cradle that holds a Nintendo Switch 2 Pro Controller (or the original Switch Pro Controller, about 152 x 106 x 60 mm) upright on a shelf with the face buttons and the GameChat C button visible. Two 30 mm wide saddles support the grips at their widest point, a 25 degree back rest keeps the controller from tipping, and a 12 mm slot along the rear lets a USB-C cable stay plugged in for charging. The stand prints in one piece on its base with 2 mm walls and a slightly hollowed underside that accepts 10 mm rubber feet.

Rather than trusting a stand modelled from a photo, you give SpeakCAD the grip spacing and controller depth you measured and it draws the saddles to match. Preview the result in the browser for nothing, ask for a second bay or an engraved logo in the chat, and download the STL when it looks right.

Get it nowGenerate and preview for free, in your browser. A download costs 2 credits.

Design a controller display stand 160 x 90 x 45 mm for a Nintendo Switch 2 Pro Controller with two grip saddles 30 mm wide spaced 95 mm apart, a rear back rest tilted 25 degrees, a 12 mm USB-C cable slot at the back, 2 mm walls and four 10 mm recesses underneath for rubber feet.

Change any number to match what you measured. The AI keeps the rest of the design consistent, and small follow-up edits after a download are free.

More hobby & gaming

ASUS ROG Ally charging stand with angled cradleAn angled cradle for the ASUS ROG Ally and ROG Ally X (280 x 111 x 21 mm at the body, up to 32 mm at the grips) that keeps the handheld upright on a desk whi…LEGO minifigure display shelf for 24 figuresA stepped, wall-hanging shelf with four tiers of six LEGO minifigures each, every figure standing on a pair of real 4.8 mm studs at the 8 mm LEGO pitch so it…Pokémon TCG toploader wall display rackA wall rack that shows twelve Pokémon TCG cards in standard 3 x 4 inch toploaders (76 x 102 mm, about 2 mm thick for a 35 pt sleeve) in three rows of four.Hexagonal dice vault with lidA dice vault stores a full seven-piece polyhedral set in a compact hex body with a friction-fit or threaded lid.Game controller stand for two padsA controller stand keeps two gamepads upright on a shelf instead of sliding around in a drawer, and it stops the analogue sticks getting crushed.Guitar pick holder with headstock clipPicks vanish constantly, and a holder that clips onto the headstock keeps four within reach mid-song.

Make your nintendo switch 2 pro controller display stand now

Nothing to install and no CAD skills needed. Describe it, watch it render, download the STL or 3MF and print it tonight.

Get it nowBrowse the library
Looking for a ready-made version? Check the marketplace, where makers sell finished, rated models for credits.