Hot Wheels wall display rack for carded cars
A wall rack for unopened Hot Wheels and Matchbox mainlines still on their blister cards, which measure 108 x 165 mm with the blister sticking out about 35 mm. Twelve angled slots in three rows hold each card upright with a 110 mm wide pocket 4 mm deep and a 20 mm lip, leaning 10 degrees back so the car faces the room and the card cannot slide out. A 3 mm back plate with a hex pattern saves filament, and four keyhole hangers at 200 mm spacing suit standard drywall anchors. It prints face-up flat on the bed, no supports, and a 6 mm wide gap between slots leaves room for Premium and Car Culture cards.
Collections grow, so a fixed rack is always one row short. Tell SpeakCAD how many cars and whether they are mainline or Premium size, preview the rack in the browser without paying, ask for a loose-car tier in the chat, then download the STL.
Design a Hot Wheels carded car wall rack 480 x 540 mm with a 3 mm hex-patterned back plate, twelve slots in three rows of four, each 110 mm wide, 4 mm deep with a 20 mm lip and 10 degree back tilt for 108 x 165 mm cards, 6 mm gaps and four keyhole hangers 200 mm apart.