Vitamix tamper holder clip for the container base
A clip that holds the Vitamix tamper upright next to the motor base so it is never rolling around a drawer or lying wet on the counter. The clip grips the tamper shaft, roughly 22 mm across on classic tampers and 19 mm on the low-profile version, with a C-shaped mouth that flexes 1 mm open and a 20 mm collar so the tamper hangs straight. A flat 40 by 60 mm back plate carries a 3M Command strip or two 3.5 mm screws, and a drip gap in the collar lets water run out. Print it lying on its back with 2 mm walls in PETG, which flexes without cracking.
Tamper shafts differ between the Ascent, Explorian and 5200 lines, so a clip generated to your measured diameter holds firmly instead of loosely. In SpeakCAD you state the shaft size and mounting method, preview the clip in the browser for nothing, refine it in the chat and download the STL.
Design a wall clip with a C-shaped collar 22.4 mm inner diameter, 20 mm tall and 2 mm thick with a 16 mm mouth opening for a Vitamix tamper shaft, a 40 x 60 mm back plate 3 mm thick with two 3.5 mm screw holes and a 4 mm drip gap at the bottom of the collar.